NITROUS OXIDE ( nos / n2o ) advice forum http://nitrous-advice.org/ |
|
I've made a right cock-up http://nitrous-advice.org/viewtopic.php?f=21&t=5984 |
Page 1 of 1 |
Author: | BMW840 [ Sun May 29, 2011 4:12 pm ] |
Post subject: | I've made a right cock-up |
In moving the main relay cluster to provide the feed for the new rev counter, I have got them all mixed up. I have no turn indicators (normal for a BMW driver) but head lights won't pop up either. To my defence I had made a note of everything, but I believe that when they were removed some time back, the relay bases were not put back in the correct positions. So a diagram is of no use. Its gonna take me a while to figure this out, much to my annoyance and embarrasssment |
Author: | mgbv8 [ Sun May 29, 2011 7:16 pm ] |
Post subject: | Re: I've made a right cock-up |
What sort of feed do you need for the rev counter Rich?? And why have you had to pull out so much stuff to get it ?? Pel |
Author: | BMW840 [ Sun May 29, 2011 7:18 pm ] |
Post subject: | Re: I've made a right cock-up |
I was going to tap into the feed going to the Max extreme as I knew that was good, but Minispeed had run the loom under the relay cluster, wish I'd never touched it. |
Author: | mgbv8 [ Sun May 29, 2011 7:22 pm ] |
Post subject: | Re: I've made a right cock-up |
So its just a clean 12volt feed you need then ?? |
Author: | BMW840 [ Sun May 29, 2011 7:30 pm ] |
Post subject: | Re: I've made a right cock-up |
mgbv8 wrote: So its just a clean 12volt feed you need then ?? I was tracing the rpm feed, I've got the Black+White wire and the switched 12v now. Just wish we'd never touched the relays, its gonna be a nightmare |
Page 1 of 1 | All times are UTC |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |