NITROUS OXIDE ( nos / n2o ) advice forum

hi

ive got a wizard of nos water in injecion kit that come with a car.it was in the car but not fitted
does anyone else use the same kit and how do they get on with it
ive never used this type of kit before, just wanted to know bit more about it

Dean

Can you post some pics of it and post details of the car its one please?

Any reports about how it's performing?

We've never sold many of those, as we persuade most people that nitrous is a better option, plus we never got round to promoting them (you'll notice we don't have them on our site yet), because we've been too busy dealing with the nitrous sales.

Im thinking of putting it on a renault 5 turbo engine thats in my van, i will try over the weekend to upload some pics.
its a small tank, blue injector, red and blue pump from the tank to a red nos solenoid. but are get some pics up.
i was just thinking of using it when i use it for the strip to help with cooling or poss use to inject methanol.
dean

Trevor, how much would i be looking at for a direct port water injection kit for a 4 cylinder engine?

Can you complete the contacts page for a response to that question please, as one of my team deal with quotations.

Thanks

Uploaded with ImageShack.us




Uploaded with ImageShack.us

sorry for the long delay

What would you like to know?

The system is fine on 100% water but is likely to corrode when using methanol.

However, you may get away with a small percentage for a while.

ive noticed the kit needs a boost pipe going to it to pressure the tank will i need to do that?
what size jets would you advise to use? be running 20psi up
and the other question was could i use methanol but i see that its not advised

thanks trevor
are get it all plumped in and are post some pics up, dont surpose you have a wiring diagram i could have?
i will need to call up for some jets and some other little bits. got a in dash nos pressure gauge that hasnt got any fittings on the back and a t piece to put it on the system.

Unfortunately not but if you send me an email to trev@noswizard.com I'll knock up a rough one for you.

Do you have a boost pressure cut off switch as well as the solenoid and pump and are you using our switches?

cut off switch? ive got a pressure switch.
same as what you sell, 2 pin outlet small adjuster screw in the middle to set the boost to switch on the pump also got a spare micro switch or could i use the same one as the nos?

are send you a email tomorrow

[quote="Noswizard"][quote="dinor5"]cut off switch? ive got a pressure switch.
same as what you sell, 2 pin outlet small adjuster screw in the middle to set the boost to switch on the pump
That's what I'm calling the boost cut off switch as that prevents the water being injected at low boost when you don't need it. I'll need to know if that's a normally open or normally closed type?

o ryt sorry i thought it myt of been a different thing,are have to check are take some photos and email them to you.

not sure if ive got room for a second switch prob be just as easy to put in a pair of relays, for the 2 kits

many thanks for all the help trevor