Well progress so far is that Ive received all the bits, as per advert, all seems really good, nice bottle and heater and also came with a gauge I didnt realise was coming so nice little bonus!!
As per above Iv spoke to Trev and the Solenoids are packaged up ready to go tomorrow with a note for bits needed! (just remembered I didnt measure the Diameter of the black/red and blue lines! Will do that and let you know Trev
)
Heres some pictures, unfortunately I think Im going to have to admit defeat and accept that the bottle is just too big for the tiny ginetta! youll see why, So I think it will be a case of set the car up with this one on the rolling road then swap it out to a smaller one when I have sold on the bigger one, funds are nearly wiped out on all this as it is lol, Ive also got three injectors and the splitter that will be sold on as they are surplus to my requirements, mine will only be using one injector upstream of the TB where I have a handy alloy joiner a few inches away
Location 1 for the bottle....
As you can see just too big for comfort, I will need a blanket/heat mat etc on whichever bottle either way to stop the sun getting to it and making it dangerous! but this location is at least between the roll cage and has metal chassis around/under it. drivers and passengers head also sit directly under the main hoop of the roll cage, really is a tiny car!
Location 2 is.......
right at the front between the rad and fuel tank, this really shows the bottle as being well too big and the bottom is right in the corner of the body so would be one of the first things to be hit in the event of a head on smash, also the chassis ends just before the bottle so its only fiberglass around it, again if the bottle was possibly smaller I could lift it out of the corner.
Other than that its a bit of a nightmare to find a location in a tiny car.
One thing that does fit in nice though is the maximiser lol...
Heres the other bits....
Look forward to some responses
Cheers
Chris