Heres a bit of an interesting question for you all to chip in hopefully!.
I have a Max Extreme with gear based power maps (counted by TPS movement).
I was thinking, I have a 2-step launch rev limiter (ignition cut type) built into my fuel management which I use when staging for 1/4 mile times. I also need to purge the nitrous system before a run..
If I set 1st gear power on the Extreme to 20% across the board, line up at staging line and hit WOT (launch control active) would the 20% (of 100bhp shot) have a detrimental effect on the engine?. How long would it take to purge 4 meters of AN3 line? (a second, three seconds?).
I normally only stage for a few seconds at WOT, 5500 rpm before launching.
Would kill 2 birds with one stone and I would have full power available for second gear..
|